← Back to knowledge hub
FLAT ROOF CONSTRUCTION & MATERIALS · 8 min

Plan a Tapered Insulation Board Layout

Tapered insulation needs a plan showing where every board thickness and valley piece belongs. Without a verified layout, water may drain incorrectly or roof details may end up too low.

FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB

Tapered insulation needs a plan showing where every board thickness and valley piece belongs. Without a verified layout, water may drain incorrectly or roof details may end up too low.

Quick answer

Survey the roof, mark drains and high points, choose an approved product system and calculate the quantity of each board type before purchasing.

Survey the existing roof

Record deck levels, falls, drains and changes of height.

An assumed level substrate may lead to unintended low points when actual deflection is ignored.

Practical tip

Measure actual levels.

Set drains and ridges

Identify catchment areas, drain positions and separating ridges. Multiple outlets can need valley and saddle arrangements.

Calculate the rise and check its feasibility around thresholds and kerbs.

Practical tip

Use the fall calculation.

Count real products

Use actual tapered insulation dimensions and thickness series, including any flat base layer.

Build a table of each board thickness, special valley piece and required offcut.

Practical tip

Do not order from an unverified sketch.

Review before ordering

Verify drainage, edge heights, emergency overflows, fixing and substrate conditions.

Keep a revision-controlled final board schedule with manufacturer or designer approval.

Practical tip

PRELIMINARY LAYOUT — VERIFY BEFORE ORDERING.

DAKCALC

Estimate roofing work with a clear material schedule and cost breakdown

Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.

Open calculator →

Explore the DakCalc flat-roof calculation cluster

Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.

Frequently asked questions

What is a valley board?

A piece used where roof fall planes form a drainage valley.

Can I order from a concept layout?

Only after checking the actual product layout.

Does existing substrate level matter?

Yes, it influences the final drainage geometry.

Sources and further reading

Reviewed in November 2026. Check current rules and software capabilities before relying on them.

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 – VEBIDAK, DAKMERK, Kiwa BDA
  2. RVO – Energieprestatie-eisen verbouw en renovatie
  3. IPLO – Energiezuinigheid bij nieuwbouw
  4. IPLO – Noodafvoersysteem platte daken

General information and illustrative calculations, not personalised legal, tax or technical advice.