← Back to knowledge hub
FLAT ROOF CONSTRUCTION & MATERIALS · 8 min

Flat Roof Falls: Calculate Millimetres per Metre

A flat-roof fall guides rainwater to an outlet. The height calculation is simple, but real drainage also depends on outlet position, substrate deflection and existing roof levels.

FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB

A flat-roof fall guides rainwater to an outlet. The height calculation is simple, but real drainage also depends on outlet position, substrate deflection and existing roof levels.

Quick answer

Multiply the horizontal run in metres by the specified fall in mm/m. A 6 m run at an illustrative 16 mm/m rises by 96 mm.

Millimetres per metre

mm/m means vertical height change for each horizontal metre. Divide by ten to obtain the percentage.

For instance 15 mm/m equals 1.5%. Measure the actual high-to-low run.

Practical tip

Use the design fall specified for the project.

Worked height example

Six metres at 16 mm/m produces 96 mm of rise. If a simplified system is 40 mm thick at the drain, it would reach 136 mm at the far end of a straight slope.

Multiple drains and valleys require different board thicknesses; this is not a complete roof design.

Practical tip

See the layout planning guide.

Worked / practical example

16 mm/m = 1.6%; 6 × 16 = 96 mm.

Review drainage paths

Map outlets, local low points and emergency overflow routes. Ponding may also involve structural deflection, especially with light roof decks.

The drainage and structural assessment should confirm capacity and ponding risks.

Practical tip

Read the drainage guide.

Convert geometry into products

Select a real tapered board system and calculate thickness-by-thickness quantities.

Verify usable heights at thresholds, kerbs and outlets before creating an order.

Practical tip

A provisional DakCalc diagram is not a confirmed supplier layout.

DAKCALC

Estimate roofing work with a clear material schedule and cost breakdown

Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.

Open calculator →

Explore the DakCalc flat-roof calculation cluster

Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.

Frequently asked questions

What is a 1% fall?

10 mm of rise per horizontal metre.

Is 16 mm/m a universal design rule?

No, it is an illustrative slope here.

Does a height calculation approve the board plan?

No, the actual layout still needs review.

Sources and further reading

Reviewed in November 2026. Check current rules and software capabilities before relying on them.

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 – VEBIDAK, DAKMERK, Kiwa BDA
  2. RVO – Energieprestatie-eisen verbouw en renovatie
  3. IPLO – Energiezuinigheid bij nieuwbouw
  4. IPLO – Noodafvoersysteem platte daken

General information and illustrative calculations, not personalised legal, tax or technical advice.