Calculate PIR Thickness for a Flat Roof
Choosing PIR thickness requires the declared conductivity, target material resistance and whole-roof build-up, not a fixed rule of thumb.
FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB
Choosing PIR thickness requires the declared conductivity, target material resistance and whole-roof build-up, not a fixed rule of thumb.
Approximate homogeneous board thickness in metres as target Rd multiplied by declared lambda. Check real commercial thicknesses and the whole-roof construction Rc separately.
Identify the target
Determine whether new construction, renovation or insulation replacement regulations apply to the roof.
The requirement for the whole roof differs from one board’s Rd.
Read Rc versus Rd.
Calculate from lambda
At lambda 0.023 W/(mK), a target Rd of 4.0 gives 4.0 × 0.023 = 0.092 m, or 92 mm theoretical thickness.
Choose a real product thickness and check its declared Rd rather than assuming identical performance across PIR products.
The formula concerns material, not the complete construction.
Check construction Rc
The complete roof resistance must be determined using the applicable regulatory calculation method.
Deck, construction layers and thermal bridging may affect the result.
Consult RVO or IPLO for the relevant Dutch requirements.
Check available detail heights
More insulation affects the height available at outlets, kerbs, edge trims and thresholds. Tapered boards vary in height.
Verify the maximum and minimum roof build-up before ordering.
See the fall calculation.
Estimate roofing work with a clear material schedule and cost breakdown
Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.
Open calculator →Explore the DakCalc flat-roof calculation cluster
Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.
Frequently asked questions
Is 100 mm PIR always sufficient?
No; the specific board and construction target determine suitability.
Is Rd equal to Rc?
No. Rd is a material-layer property, Rc a construction value.
Where can I find lambda?
In the selected product’s technical data.
Sources and further reading
Reviewed in November 2026. Check current rules and software capabilities before relying on them.
General information and illustrative calculations, not personalised legal, tax or technical advice.