← Back to knowledge hub
ROOFING WORK PREPARATION & PROJECT PLANNING · 10 min

Flat Roof Work Preparation: Survey to Installation

Flat roof work preparation starts with a dependable survey and continues beyond ordering materials. Drainage, junctions, site safety, crew logistics and unexpected damage influence whether the job can actually be

ROOFING · WORK PREPARATION & PROJECT PLANNING

Flat roof work preparation starts with a dependable survey and continues beyond ordering materials. Drainage, junctions, site safety, crew logistics and unexpected damage influence whether the job can actually be executed.

Quick answer

Record roof geometry, layers, drainage, details, substrate, access and risks. Confirm the repair or new-installation scope, prepare measurements, then organize materials, crew sequence, instructions and handover checks.

Inspect the roof and deck

Measure horizontal fields and upstands and, where access is safe, assess existing waterproofing, insulation, drainage falls, outlets and damage.

Record suspected moisture or leaks as assumptions until investigated. Use the roof survey checklist to capture penetrations, rooflights and edges.

Resolve junction details before estimating

Increased insulation thickness may change levels at trims, doors, outlets and wall flashings. Specify the selected approved details before ordering.

The technical detail guide supports separate quantities for upstand strips, edge strips and profiles. Wind and attachment design require project-specific verification.

Prepare an execution-ready job pack

Provide scope, marked-up roof plan, bill of materials, supplier lead times, labour estimate and temporary weatherproofing plan if needed.

Connect these to the estimate and job sequence. Check the compatibility of every specified component.

Check safety and brief the crew

Assign responsibility for safe roof access, collective edge protection, lifting, hot works, site boundaries and emergency procedures. Validate the workplace against its risk assessment and actual conditions.

Dutch Arboportaal guidance prioritizes risk elimination and collective protection where fall hazards exist.

Practical note

A checklist cannot replace a site-specific safety assessment.

Control unexpected changes

If stripping exposes wet insulation or an unsuitable deck, confirm revised scope, labour and materials before proceeding.

Reflect approved changes in the job record and material orders.

DAKCALC

From roof survey to material list and job record

Use DakCalc’s available roof area, material and document workflows; verify technical details, site safety and system specifications for each project.

Open calculator →

More work preparation guides

Also see: technical roof calculations · roofing quotation.

Frequently asked questions

What is needed before flat roof estimating?

Measurements, existing construction, details, system choice, safe access, risk controls and unresolved assumptions.

Is an aerial picture enough for a roof plan?

No. It cannot reliably establish hidden layers, details and actual site conditions.

When is another survey necessary?

When moisture, structural conditions or job scope remain uncertain.

Sources and references

  1. Arboportaal — Werken op hoogte, maatregelen en RI&E
  2. Arboportaal — Wettelijke regels voor werken op hoogte
  3. DAKMERK / VEBIDAK / Kiwa BDA — Vakrichtlijn gesloten dakbedekkingssystemen 2025

Examples are illustrative and are not a site safety plan or engineered roof design. Verify fall protection, structural capacity, wind loading, methods and product specifications before work.