← Back to knowledge hub
ROOF REPAIRS & LEAKS · 7 min

Repairing Blisters in Bitumen Roofing

Bitumen blisters are symptoms requiring assessment rather than an invitation to puncture the membrane. Check location, bonding and potential moisture before choosing a repair.

FLAT ROOFS · REPAIR & LEAKS

Bitumen blisters are symptoms requiring assessment rather than an invitation to puncture the membrane. Check location, bonding and potential moisture before choosing a repair.

Quick answer

Record blister sizes and locations, inspect the surrounding membrane and determine whether moisture or adhesion issues call for further investigation. Only then specify a compatible system repair.

Assess each blister in context

Mark location, dimensions and proximity to laps, penetrations and drainage paths. A localized stable blister is different from widespread loss of adhesion.

Visual inspection cannot definitively establish moisture beneath the membrane; investigate further when needed.

Investigate adhesion and trapped moisture

Moisture or vapour between layers, preparation issues and movement can contribute. Consider what the actual build-up tells you before deciding on an opening.

Wet insulation or extensively disbonded layers may require more than a local patch.

Apply a system-approved repair

The Dutch 2025 guideline describes controlled treatment and leveling of blisters followed by suitable membrane repairs. Confirm repair dimensions and bonding requirements against the selected system.

Use appropriate fire-safe methods where hot work may affect combustible construction details.

Calculate and document repairs

Count blisters, record dimensions and allow for the full repair strip with required connections. Check whether any existing offcuts are genuinely suitable.

Photograph before and after, record the scope on the work order, and consider overlay or replacement for extensive defects.

DAKCALC

From roof inspection to a clear job record

Record the job, materials and labour; verify the repair specification and costs before work starts.

Explore DakCalc →

More flat roof repair guides

For roof material calculations: the DakCalc technical guide.

Frequently asked questions

Is every blister a roof leak?

No. Blisters can exist without active water ingress.

Will puncturing the blister fix it?

Not on its own; it can create a new water path.

When is broader work needed?

Where moisture, poor bonding or widespread damage is established.

Sources and further reading

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 — VEBIDAK / DAKMERK / Kiwa BDA
  2. Kiwa BDA — Vakrichtlijn en technische achtergronden

Inspection and costing are indicative. Check the roof build-up, moisture, adhesion, wind resistance and fire safety for each project against the relevant system instructions.