← Back to knowledge hub
EPDM, PVC & ROOF MEMBRANE SYSTEMS · 8 min

PVC Roofing Welded Seams and Junctions

PVC roofing membranes are connected by controlled thermoplastic welding to form a continuous waterproof layer. Joint quality depends on the exact product, seam cleanliness, equipment, weather and inspection.

ROOF MEMBRANE SYSTEMS · EPDM, PVC & BITUMEN

PVC roofing membranes are connected by controlled thermoplastic welding to form a continuous waterproof layer. Joint quality depends on the exact product, seam cleanliness, equipment, weather and inspection.

Quick answer

Confirm membrane and accessory compatibility, keep overlap zones clean and dry, set welding equipment for the particular product and conditions, and inspect joints using the required procedure. Measure long seams, cross-joints and vertical details independently.

Prepare clean compatible weld zones

The 2025 Dutch guideline requires careful sheet positioning and clean seam surfaces, avoiding bitumen and grease in welding zones.

Check dust, moisture, coatings and aged sheet condition, and use only cleaning procedures approved for the selected PVC system.

Plan the overlap and joining method

Side laps are prescribed by the roofing system and may need room for fixing plates or sleeves with concealed mechanical fixing.

Connect the sheet layout to PVC roll quantities and the fixing plan.

Set the welder using product guidance

Heat, travel speed, pressure and nozzle selection depend on the sheet and approved welding equipment. One temperature cannot be prescribed for every PVC membrane.

Perform the trial welds and tests required by manufacturer and site procedures; reassess after changes in temperature or conditions.

Practical note

This article deliberately does not supply a universal welding temperature or width.

Inspect intersections and detail joints

T-joints, corners, outlets and upstands need continuous approved welded details, not just visually neat sheet edges.

Document the inspection and rectify defects according to the approved procedure before handover.

DAKCALC

Estimate roof area and costs; verify the selected roof system

Use DakCalc where its current roof area, material and cost tools match the job. Adhesive rates, welded seam details and wind-uplift fixing layouts are not automatically certified DakCalc designs; use manufacturer data and project-specific specifications.

Open DakCalc →

More membrane system guides

See also: APP versus SBS bitumen, roof edge trims for EPDM, PVC and bitumen, Rhepanol (PIB) roofing.

Frequently asked questions

What temperature should a PVC roof welder use?

Use the membrane manufacturer's tested parameters for the actual equipment and conditions.

Can PVC be welded over greasy seams?

No. Prepare and clean joint surfaces properly.

Is any lap width suitable?

No. Welding and attachment specifications determine the required lap geometry.

Sources and references

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 — VEBIDAK / DAKMERK / Kiwa BDA
  2. Vakrichtlijn 2025 PDF — Kiwa BDA (product- en systeemspecifieke details)
  3. Kiwa BDA — Toelichting bij de Vakrichtlijn 2025

Calculations and service-life comparisons are indicative. Verify the selected product, chemical compatibility, installation requirements, fire safety, wind resistance and roof construction; examples are not approved specifications.