← Back to knowledge hub
EPDM, PVC & ROOF MEMBRANE SYSTEMS · 8 min

Calculate Mechanical Fixings for PVC Roofing

Mechanically attaching PVC roofing cannot be designed from an arbitrary screws-per-square-metre rule. Wind uplift varies with building location, height, roof shape, perimeter zones and deck resistance.

ROOF MEMBRANE SYSTEMS · EPDM, PVC & BITUMEN

Mechanically attaching PVC roofing cannot be designed from an arbitrary screws-per-square-metre rule. Wind uplift varies with building location, height, roof shape, perimeter zones and deck resistance.

Quick answer

Obtain a project-specific wind design and approved attachment specification. Check deck pull-out resistance, PVC sheet, plates or sleeves, seam fastening or alternative induction fixing. Only then count the fasteners by zone and order the actual pack quantities.

Determine wind zones and building conditions

Building height, location and corner and perimeter zones affect design uplift. Penetrations and roof-level changes can also matter.

Obtain a site-specific fixing layout from a qualified designer or system supplier. One blanket rate cannot substitute for this assessment.

Confirm deck and fastener performance

Approved fasteners differ for steel, timber and concrete decks and by insulation build-up. Embedment and pull-out capacity require more than an insulation thickness guess.

Use system-tested screws, plates or sleeves with adequate substrate resistance and any needed pull-out test results.

Coordinate sheet layout with attachment

The Dutch guideline lists concealed lap fixing, through-sheet fixing with PVC cover strips and induction methods. The chosen arrangement affects sheet widths, weld laps and perimeter restraint.

PVC sheet takeoff must reflect the approved attachment layout.

Convert an approved layout into packs

Count actual design points for fields, perimeters and corners. Apply any specified ordering reserve, then round up to full supplier packages.

For illustration, a verified plan calling for 240 fasteners and 100-per-box packaging requires at least three boxes before optional spare stock. This does not establish fixing density.

Practical note

240 points ÷ 100 per box = 2.4, so order 3 full boxes.

DAKCALC

Estimate roof area and costs; verify the selected roof system

Use DakCalc where its current roof area, material and cost tools match the job. Adhesive rates, welded seam details and wind-uplift fixing layouts are not automatically certified DakCalc designs; use manufacturer data and project-specific specifications.

Open DakCalc →

More membrane system guides

See also: APP versus SBS bitumen, roof edge trims for EPDM, PVC and bitumen, Rhepanol (PIB) roofing.

Frequently asked questions

Are five fasteners per square metre enough?

Not possible to determine without project wind design, substrate and approved system.

Where are PVC fasteners installed?

Depending on the system: in laps, through-sheet with cover strips or via an approved induction method.

Can DakCalc certify a fixing layout?

No. A qualified supplier or designer must provide the project-specific plan.

Sources and references

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 — VEBIDAK / DAKMERK / Kiwa BDA
  2. Vakrichtlijn 2025 PDF — Kiwa BDA (product- en systeemspecifieke details)
  3. Kiwa BDA — Toelichting bij de Vakrichtlijn 2025

Calculations and service-life comparisons are indicative. Verify the selected product, chemical compatibility, installation requirements, fire safety, wind resistance and roof construction; examples are not approved specifications.