← Back to knowledge hub
ROOF REPAIRS & LEAKS · 7 min

Repair a Leaking Roof Edge or Wall Junction

Water may enter a flat roof where the membrane meets an edge trim, parapet or masonry wall. Repairing the visible gap is not sufficient if the underlying waterproof junction is poorly designed.

FLAT ROOFS · REPAIR & LEAKS

Water may enter a flat roof where the membrane meets an edge trim, parapet or masonry wall. Repairing the visible gap is not sufficient if the underlying waterproof junction is poorly designed.

Quick answer

Measure the affected run and inspect the trim, membrane, upstand height, lead flashing or termination bar and substrate. Repair the complete junction using details compatible with the actual roof system.

Assess the membrane-to-edge transition

Inspect the transition between horizontal membrane and vertical upstand. Check for detached upstand strips, incompatible trims, unsecured termination or water ingress behind the junction.

Also inspect masonry joints, anchors and clamp-bar fixings where present.

Do not confuse lead and termination-bar details

Lead stepped into a masonry joint can use proper jointing and mechanical retention; a clamped termination detail can specify an appropriate sealant. Their finishing methods are not interchangeable.

See the wall flashing technical guide for lead joints, repointing, repair tape and termination bars.

Measure linear runs and strip widths

Calculate trims as linear metres including connectors and corners. Schedule membrane strips separately using actual unrolled width, prescribed overlaps and the selected profile.

For illustration, a 6 m wall connection with a hypothetical 0.30 m-wide strip consumes 1.8 m² nominal material before laps and offcuts.

Important

This is arithmetic, not an approved construction dimension.

Agree the exact work scope

Specify whether work includes only the membrane junction or also damaged flashing, masonry pointing, upstand insulation or trim replacement. Inspect the complete detail after work.

Use a written quotation to distinguish agreed items and potential hidden repairs.

DAKCALC

From roof inspection to a clear job record

Record the job, materials and labour; verify the repair specification and costs before work starts.

Explore DakCalc →

More flat roof repair guides

For roof material calculations: the DakCalc technical guide.

Frequently asked questions

Will a bead of sealant fix every leaking roof edge?

No. The underlying waterproofing and termination must be correctly detailed.

Is silicone the default for mortar-pointed lead?

No. A pointed lead joint and a sealed clamping bar are different systems.

How are edge trims measured?

As linear runs with relevant corners, connectors and approved fixings.

Sources and further reading

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 — VEBIDAK / DAKMERK / Kiwa BDA
  2. Kiwa BDA — Vakrichtlijn en technische achtergronden

Inspection and costing are indicative. Check the roof build-up, moisture, adhesion, wind resistance and fire safety for each project against the relevant system instructions.