← Back to knowledge hub
FLAT ROOF CONSTRUCTION & MATERIALS · 8 min

Mechanical Fixings for PIR: Screws and Plates

Mechanically fixed PIR roof insulation uses suitable screws and load-distributing washers or plates. The true fastener schedule must follow the deck, wind-load and product design.

FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB

Mechanically fixed PIR roof insulation uses suitable screws and load-distributing washers or plates. The true fastener schedule must follow the deck, wind-load and product design.

Quick answer

Use a provisional fastener count only for budgeting. Approve the quantity, pattern, screw specification and anchorage for the actual roof before installation.

Choose the specified fixing method

Mechanical fixing depends on substrate, chosen insulation and approved roof-system build-up.

A mechanically attached roof differs from a fully adhered specification and requires a coordinated technical design.

Practical tip

Review product and installation approvals.

Calculate a provisional count

At an assumed five fasteners per m², 60 m² gives 60 × 5 = 300.

Corners and edge zones can need a different spacing or system arrangement. Never represent this estimate as an approved wind-load design.

Practical tip

Obtain the project-specific fastening specification.

Choose screw length and plates

A shortcut such as board thickness plus 20 mm is not a general rule because deck type and required embedment vary.

Specify compatible washers or pressure plates and corrosion-resistant fasteners according to the manufacturer.

Practical tip

Review all layers and actual anchorage depth.

Purchasing and labour

Keep fasteners, washers, pack quantities and remaining stock as separate material records.

Estimate labour for board layout, drilling or fixing, checks and safe access.

DAKCALC

Estimate roofing work with a clear material schedule and cost breakdown

Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.

Open calculator →

Explore the DakCalc flat-roof calculation cluster

Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.

Frequently asked questions

Are five fixings per square metre always sufficient?

No, this is only a costing illustration.

Is screw length always PIR thickness plus 20 mm?

No, anchorage and substrate requirements govern.

Do plates need separate quantities?

Yes, where the system requires them.

Sources and further reading

Reviewed in November 2026. Check current rules and software capabilities before relying on them.

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 – VEBIDAK, DAKMERK, Kiwa BDA
  2. RVO – Energieprestatie-eisen verbouw en renovatie
  3. IPLO – Energiezuinigheid bij nieuwbouw
  4. IPLO – Noodafvoersysteem platte daken

General information and illustrative calculations, not personalised legal, tax or technical advice.