Mechanical Fixings for Flat Roof Insulation
Insulation screws and pressure plates may look like simple consumables, but mechanical attachment must suit the insulation, deck, wind zones and tested roof assembly.
FLAT ROOF · SAFETY, WIND & SOLAR
Insulation screws and pressure plates may look like simple consumables, but mechanical attachment must suit the insulation, deck, wind zones and tested roof assembly.
Use an approved fixing plan by roof zone. Verify board dimensions, deck, screw, plate, embedment and product specification; count actual fixing points and then round to supplier pack sizes.
Specify the complete roof assembly
Identify deck, board thickness, insulation layers, vapour control and waterproofing. The insulation fixing strategy must work with the whole assembly.
Obtain wind design from the load study and zone drawing.
Verify screw, plate and deck
Choose compatible fasteners and plates with appropriate corrosion protection and approved embedment. Adding 20 mm to insulation thickness is not a universal engineering rule.
For example, an 80 mm board and 100 mm nominal screw may look plausible for preliminary stock, but actual length depends on all layers and embedment.
DakCalc default values are editable estimates, not an engineering approval.
Count approved fixing points
Layouts can differ across corners, perimeter, field and individual insulation boards. Count each actual point by fastener type.
An approved 165-point schedule with 100-per-box screws and plates needs at least two boxes of each, before spares; that does not define safe density.
165 / 100 = 1.65, rounded up to two packs per component.
Connect purchasing to execution records
Keep the approved drawing revision with the job, check actual deck conditions and record any required pull-out tests or deviations.
Use material schedules and work preparation for tracking; technical approval remains separate.
Build a traceable roofing estimate
Use supported DakCalc tools for roof quantities and costs. DakCalc does not certify wind loads, solar ballast, structural capacity or fall-protection plans; these require appropriate qualified design and verification.
Open DakCalc →Related safety and solar guides
Also see: roofing work preparation · flat roof calculations.
Frequently asked questions
Are five screws per m² always adequate?
No. A fixed density cannot replace a compliant wind and system design.
Is screw length always insulation thickness plus 20 mm?
No. Full build-up and specified embedment govern selection.
Can I count packs after the fixing design is approved?
Yes. Use the approved point counts and real pack quantities.
Sources and standards
- Arboportaal — Werken op hoogte
- Arboportaal — Wettelijke maatregelen tegen valgevaar
- RVO — Geschikte daken voor zonne-energie
- RVO — Veiligheid en verzekerbaarheid zonnepanelen
- IPLO — Noodafvoer en wateraccumulatie
- NEN 7250:2021 — Bouwkundige aspecten zonne-energiesystemen
- NEN-EN 1991-1-4:2026 — Eurocode windbelasting (controleer toepasselijke Nederlandse normeditie)
This guide is informational, not engineering approval or a safety instruction. Confirm applicable standards and national annexes, structural design, manufacturer installation guidance, site risk assessment and insurer requirements.