← Back to knowledge hub
FLAT ROOF RENOVATION & OVERLAYS · 8 min

Adding Flat Roof Insulation During Renovation

Adding insulation during flat-roof renovation requires a coordinated design for thermal performance, vapour control, roof height and drainage. Simply adding PIR boards without checking junctions can introduce

FLAT ROOF · RENOVATION & OVERLAYS

Adding insulation during flat-roof renovation requires a coordinated design for thermal performance, vapour control, roof height and drainage. Simply adding PIR boards without checking junctions can introduce defects.

Quick answer

Assess the old build-up, moisture, vapour control and available upstand heights. Select boards for the required thermal performance and compatible assembly, then adjust outlets, edges and penetrations where extra height demands it.

Inspect the existing build-up and moisture

Determine the insulation, vapour-control layer and existing fixing arrangement. Wet boards or an uncertain vapour-control strategy can require specialist investigation.

The Dutch 2025 guideline allows an existing membrane to function as a vapour-control or closure layer in some approved thermal renovation assemblies; this is not a universal rule.

Set insulation performance from product data

Insulation Rd is based on product thermal resistance, while Rc covers the complete construction. Check product λ values, chosen thickness and applicable building requirements.

For 2026 Dutch ISDE roof insulation, RVO states a minimum Rd of 3.5 m²K/W for the newly installed insulation, subject to further eligibility requirements. See the insulation technical guide.

Practical note

RVO does not allow existing insulation to be added to the new material's minimum Rd requirement for this subsidy.

Check roof level, falls and wind uplift

Extra board thickness changes the height at parapets, doors, rooflights, wall flashings and outlets. Check drainage paths and required detail heights before deciding the board stack.

Fixing density and wind resistance depend on the actual substrate, roof zones and specified system. Roof falls calculations are indicative, not a supplier-approved laying design.

Quantify insulation and ordering

Measure roof area, board sizes and cutting layout, separately for flat and tapered insulation. Select fixings using the actual system design.

Distinguish installed boards from full packs purchased and stock already available in the material schedule.

Worked example

40 m² divided by 1.2 × 0.6 m boards equals 55.56: at least 56 whole boards theoretically, before offcuts and layout allowances.

DAKCALC

Prepare a traceable renovation estimate

Measure roof areas and junctions, prepare a materials list and estimate hours and costs. Verify the real roof build-up and product requirements before work.

Open the calculator →

More on renovation and roof systems

For the repair-versus-renovation decision: overlay or replace?.

Frequently asked questions

Can the old membrane act as vapour control?

In some approved constructions, after checking the total assembly and detailing.

Are Rd and Rc identical?

No. Rd describes a product's thermal resistance; Rc represents the complete construction.

Can existing insulation count towards new ISDE minimum Rd?

RVO states it cannot be added to the newly installed insulation's minimum Rd.

Sources and reference material

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 — DAKMERK, VEBIDAK en Kiwa BDA
  2. Milieu Centraal — Asbestdak: herkennen en veilig laten verwijderen
  3. Afvalscheidingswijzer — Dakbedekking, bitumen en teer
  4. RVO — ISDE en actuele isolatievoorwaarden

Examples are illustrative. Roof build-up, moisture, structural capacity, wind loading, fire safety, waste classification and membrane specifications require project-specific checks.