← Back to knowledge hub
FLAT ROOF CONSTRUCTION & MATERIALS · 8 min

Calculate Roofing Membrane Side and End Laps

Side and end laps allow watertight membrane seams but reduce effective roll coverage. They are technical requirements, not arbitrary waste allowances.

FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB

Side and end laps allow watertight membrane seams but reduce effective roll coverage. They are technical requirements, not arbitrary waste allowances.

Quick answer

A simplified net roll coverage equals (roll length minus end lap) multiplied by (roll width minus side lap), using the actual product seam requirements.

Side and end joints

A side lap runs along parallel strips; an end lap connects successive lengths.

More end joints and more parallel rows mean different cumulative overlap use.

Practical tip

Check the specified lap dimensions.

Net roll coverage

For a hypothetical 10 m roll with 0.15 m end lap and 1 m width with 0.10 m side lap, the simplified result is 9.85 × 0.90 = 8.865 m².

First and last rows, cut strips and installed direction can change the real total.

Practical tip

These numbers illustrate the method, not required lap widths.

Calculate each layer separately

Underlays and capsheets can have different roll lengths and seam requirements.

Their strip joints may require particular staggering or sequence under the system specification.

Never trade lap size for savings

Seam dimensions and attachment procedures must follow the selected membrane system.

Do not shrink required laps to make an estimate meet a budget.

Practical tip

Review manufacturer details and the applicable roofing guidance.

DAKCALC

Estimate roofing work with a clear material schedule and cost breakdown

Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.

Open calculator →

Explore the DakCalc flat-roof calculation cluster

Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.

Frequently asked questions

Is 100 mm always the correct side lap?

No, it is only an example in this article.

Do both membrane layers have identical laps?

Not necessarily.

Why make a strip layout?

It establishes real joint counts and offcuts.

Sources and further reading

Reviewed in November 2026. Check current rules and software capabilities before relying on them.

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 – VEBIDAK, DAKMERK, Kiwa BDA
  2. RVO – Energieprestatie-eisen verbouw en renovatie
  3. IPLO – Energiezuinigheid bij nieuwbouw
  4. IPLO – Noodafvoersysteem platte daken

General information and illustrative calculations, not personalised legal, tax or technical advice.