← Back to knowledge hub
FLAT ROOF CONSTRUCTION & MATERIALS · 8 min

Calculate Flat-Roof Upstand Strips

Upstand strips waterproof the change of plane between a roof field and an upstand. Their quantities depend on linear length and required developed strip width.

FLAT ROOF TECHNOLOGY · DAKCALC KNOWLEDGE HUB

Upstand strips waterproof the change of plane between a roof field and an upstand. Their quantities depend on linear length and required developed strip width.

Quick answer

Measure the actual upstand length and multiply by the specified developed strip width, then add required end laps and cutting allowances.

Measure true upstand lengths

Identify the changes of plane, parapets, rooflight kerbs and wall junctions that receive this detail.

Avoid counting a wall flashing length twice if it is already included in another line item.

Practical tip

Use a marked-up roof perimeter diagram.

Determine developed width

The required width includes the prescribed horizontal and vertical connections.

A 0.30 m strip along 20 m nominally represents 6 m² of material before cuts and joints.

Practical tip

The manufacturer detail sets the actual width.

Allow for joints and offcuts

Corners and short pieces may require additional joins and cutting.

An illustrative budget allowance of 10% changes 6.0 to 6.6 m², but the true requirement follows the layout.

Practical tip

10% is an estimating assumption, not a technical rule.

Convert into purchase rolls

Check how many strips can be cut from the selected roll width and count complete rolls.

Add preparation, priming where specified, application and corner detailing labour.

Practical tip

See the roof detail guide.

DAKCALC

Estimate roofing work with a clear material schedule and cost breakdown

Prepare an initial calculation and verify dimensions, materials, labour and prices before issuing documents.

Open calculator →

Explore the DakCalc flat-roof calculation cluster

Start with the calculation hub, three pillars and practical guides for insulation, membrane quantities and roof details.

Frequently asked questions

Does every roof edge need an upstand strip?

Only where the specified junction requires one.

Is 300 mm always sufficient?

No; check the actual system detail.

Can area alone determine orders?

Not without a cutting and roll layout.

Sources and further reading

Reviewed in November 2026. Check current rules and software capabilities before relying on them.

  1. Vakrichtlijn gesloten dakbedekkingssystemen 2025 – VEBIDAK, DAKMERK, Kiwa BDA
  2. RVO – Energieprestatie-eisen verbouw en renovatie
  3. IPLO – Energiezuinigheid bij nieuwbouw
  4. IPLO – Noodafvoersysteem platte daken

General information and illustrative calculations, not personalised legal, tax or technical advice.