← Back to knowledge hub
ROOF INSULATION, SUBSIDIES & ENERGY SAVINGS · 8 min

Calculate Heat Loss Through a Flat Roof

Heat loss through a flat roof depends on the whole-assembly U-value, area and temperature difference. A simple heat-transfer estimate is useful for understanding but not a full building-energy assessment.

ROOF INSULATION · SUBSIDIES, BBL & ENERGY

Heat loss through a flat roof depends on the whole-assembly U-value, area and temperature difference. A simple heat-transfer estimate is useful for understanding but not a full building-energy assessment.

Quick answer

For steady-state transmission use Q = U × A × ΔT in watts. Compare pre- and post-insulation U for indicative savings; annual values need weather, degree days and building system data.

Use whole-roof U and area

A lower U-value means less heat flow. Use assembly U, not a value derived from insulation product Rd alone.

Rd and Rc have different meanings.

Calculate instantaneous heat flow

Assume 40 m², U = 0.30 W/(m²K) and 20 K difference. Q = 0.30 × 40 × 20 = 240 W.

This is heat loss at that moment under the assumed steady-state conditions, not an annual energy figure.

Worked example

0.30 × 40 × 20 = 240 watts.

Compare before and after

If an old U of 1.0 becomes 0.30 on 40 m², the modelled instantaneous reduction at 20 K is (1.0 − 0.30) × 40 × 20 = 560 W.

Actual conditions vary by climate, occupation and the rest of the building.

Estimate annual loss with disclosed assumptions

Heating degree days can approximate seasonal conductive heat flow; boiler efficiency, heat pump COP, ventilation and gains require additional modelling.

See the energy savings guide.

DAKCALC

From roof measurements to a traceable estimate

Use DakCalc’s existing material, quantity and cost workflows. Subsidy eligibility, statutory Rc compliance and energy savings are not automatically certified.

Open calculator →

More insulation guides

Additional technical reading: PIR, EPS and tapered insulation · roof renovation.

Frequently asked questions

How much heat does a 40 m² roof lose?

It depends on U and temperature difference; an example is 240 W at U 0.30 and ΔT 20 K.

Does 240 W mean annual use?

No. Power in watts differs from energy in kWh.

Can U be calculated from PIR alone?

Not reliably for the whole construction without other layers and corrections.

Official sources (check for updates)

  1. RVO — ISDE isolatiemaatregelen woningeigenaren (voorwaarden en actuele tarieven)
  2. RVO — ISDE aanvraagproces en bewijsstukken
  3. RVO — Meldcodelijst isolatiematerialen
  4. IPLO — Bbl energiezuinigheid bij nieuwbouw
  5. IPLO — Bbl artikel 5.20 energiezuinigheid bij verbouw

Content reviewed 13 November 2026. This information is not regulatory or engineering approval. Rates and rules can change; verify eligibility, evidence, moisture safety and structural suitability per project.